Node information
Name Uptime System Information Location Contact Ports Delta (bandwidth calculations)
biznes 161d 19h 3m Linux biznes 2.6.18-274.18.1.el5PAE #1 SMP Thu Feb 9 13:25:50 EST 2012 i686 Unknown root@localhost ports: 5 free: 1
AdminUpFree: 0
configured: 600s (+200.00s)
used: 720s


Interface information
Index Name Actions Admin status Oper status Speed Duplex Load In Load Out IP bpsIn bpsOut Pkt err/disc Last traffic
1 lo Trends up up 10.00 Mbit   0.25 0.25 127.0.0.1/8 24.79 Kbps 24.79 Kbps 0.0/0.0/0.0/0.0 0d 0h 0m
2 eth0 Trends up up 1.00 Gbit full 0.05 0.00 192.168.77.9/24 469.89 Kbps 10.57 Kbps 0.0/0.0/0.0/0.0 0d 0h 0m
3 eth1 Trends up up 1.00 Gbit full 0.00 0.00 172.16.65.68/29 0.00 bps 0.00 bps 0.0/0.0/0.0/0.0 0d 0h 5m
4 eth2 Trends up up 1.00 Gbit full 0.00 0.00 10.50.177.254/24 10.50.182.254/24 182.16 bps 46.16 bps 0.0/0.0/0.0/0.0 0d 0h 0m
5 eth3 Trends up up 1.00 Gbit full 0.00 0.01 172.50.1.2/24 24.06 Kbps 58.85 Kbps 0.0/0.0/0.0/0.0 0d 0h 0m
6 sit0 Trends down down           0.00 bps 0.00 bps 0.0/0.0/0.0/0.0 (NoData)


Configuration information
Globally excluded interfaces none
Excluded interfaces from traffic tracking none
Excluded interfaces from property tracking none
Interface traffic load thresholds warning at 101%, critical at 101%
Interface packet error/discard thresholds errors: warning at 1000 pkts/s, critical at 5000 pkts/s; discards: warning at 1000 pkts/s, critical at 5000 pkts/s
Interface property tracked ifOperStatus, ifStatus, ifVlanNames
Interface property change thresholds no warning threshold, no critical threshold
Bandwidth monitoring capacity Using 32-bit counters, with delta 600. Can monitor a bandwidth of 42.75 Mbps maximum. If not enough, consider decreasing delta
Other
eth2 (4): use of 32-bit counters not recommended with high speed interfaces like. If possible, consider the use of highperf mib (--64bits).
eth3 (5): use of 32-bit counters not recommended with high speed interfaces like. If possible, consider the use of highperf mib (--64bits).
eth1 (3): use of 32-bit counters not recommended with high speed interfaces like. If possible, consider the use of highperf mib (--64bits).
eth0 (2): use of 32-bit counters not recommended with high speed interfaces like. If possible, consider the use of highperf mib (--64bits).


back back reset table reset table